PLC Training Courses

Industrial Training - The Best for Less

PLC Training

GE Fanuc Series 90-70 Communications and Specialty Modules

Communications and Specialty Modules

Communication and Specialty Modules – The Series 90-70 PLC system offers an array of Communications Modules supporting the most common communications protocols and configurations such as bus controllers and Ethernet. These Modules enable communication with a range of devices such as remote drops, additional racks, and even interfacing with various products up to 7500 feet from the PLC. Specialty Modules allow interfacing with high-speed counters, Programmable Coprocessor Modules, hard disk drives, and even single board personal computers. The table below illustrates the versatility of Communication and Specialty Modules available.

PART NUMBERTYPEDESCRIPTION
IC697CMM711COMMUNICATIONSERIAL COPROCESSOR, CCM, RTU, SNP, & SNPx PROTOCOLS
IC697CMM742COMMUNICATIONETHERNET INTERFACE
IC697VRM015COMMUNICATIONREFLECTIVE MEMORY, 256K, 512 TRANSFER FIFO; 170 MBAUD FIBER OPTIC NETWORK SUPPORTS 256 NODES TO 2000 METERS
IC697RCM711COMMUNICATIONREDUNDANCY COMMUNICATIONS HOT STANDBY MODULE
IC697BEM711I/O INTERFACEBUS RECEIVER, 1 PER EXPANSION RACK
IC697BEM713I/O INTERFACEBUS TRANSMITTER WITH PARALLEL PROGRAMMING PORT
IC697BEM731I/O INTERFACEGENIUS I/O BUS CONTROLLER
IC697BEM733I/O INTERFACEGENIUS REMOTE I/O SCANNER
IC697BEM761I/O INTERFACEI/O INTERFACE FOR SERIES 6+ PLCs
IC697HSC700SPECIALTYHIGH SPEED COUNTER
IC697PCM711SPECIALTYPROGRAMMABLE COPROCESSOR
IC697VSC096SPECIALTYSINGLE BOARD COMPUTER, 300MHZ, 32 MB SDRAM, 96 MB FLASH
IC697VHD001SPECIALTY10 GB HARD DRIVE FOR IC697VSC096 COMPUTER

Purchase GE Fanuc PLCs

Click for PLC Programming Training